Double Shower Curtain Rod Installation Instructions

Verify that the rod sections are the proper length for your installation.

Double shower curtain rod installation instructions.

Gently tap the anchors into the pilot holes with a hammer. Install your brackets using these marks for a level rod. Drill pilot holes for the wall anchors. For rods 84 and longer assemble with the connector piece.

It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket. Attach the rod and brackets to the wall with the mounting hardware provided. Hold it while you level the rod. If there is a stud in your mounting location use wood screws to attach the wall brackets.

Straight double shower curtain rod installation 5. There should be no gap between the base of the wall plate and the end of the rod. Starting from the left side thread one ring through the holes of both the curtain and the liner. Continue threading until all 12 rings have been threaded through all 12 holes.

Once you find the proper height level the shower rod. If not trim with a hacksaw. Then move on to the next hole repeating the same process. 7 slide the 2nd wall plate into the rod as shown below see figure d.

In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home. Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than. The method may vary by manufacturer. How to install spring loaded shower curtain rods.

Lay the rod sections on the floor. Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. Place the wall brackets onto the ends of the shower rod and tighten the set screws secure. Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.

6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c. X pilot hole anchor. Then install the rod and place a level across the length of the rod. Thread the shower curtain hooks rings through the curtain and liner.

Using the hardware that is incl.